I use a Lenovo laptop and in the setting of Ubuntu and I don't see any reading of the mic but the speakers are working and I tried many ways but still not working.
If solved, thanks in advance!
I use a Lenovo laptop and in the setting of Ubuntu and I don't see any reading of the mic but the speakers are working and I tried many ways but still not working.
If solved, thanks in advance!
No microphone input on Acer Aspire One and Lenovo Ideapad 310-15ISK/330-15ARR
Install pavucontrol, unlink the microphone channels and turn down the left one to 0.
Some applications (e.g. chromium) can change microphone levels causing the same issue, a workaround is to remap stereo input to mono and use the remapped device as default.
Another Possible Cause
Another possible cause is that your mic has two channels but only one channel can provide a valid sound signal. The solution is to remap the stereo input to a mono input:
Find your source name from the following command; mine is alsa_input.pci-0000_00_1f.3.analog-stereo
pacmd list-sources | grep 'name:.*input'
Edit /etc/pulse/default.pa
and add the following lines, where INPUT_NAME is name of the input source from above step:
load-module module-remap-source source_name=record_mono master=INPUT_NAME master_channel_map=front-left channel_map=mono
set-default-source record_mono
Restart PulseAudio:
$ pulseaudio -k
$ pulseaudio --start
Now record
hopefully works. You may still need to change the RecordStream
from setting to Remapped Built-in Audio Analog Stereo
of a specific application in the Recording
tab of pavucontrol
.
for reference check this out:https://wiki.archlinux.org/index.php/PulseAudio/Troubleshooting#Another_Possible_Cause
You can try deleting the pulseaudio configuration files:
rm -rf ~/.config/pulse/
Then log out and log back in, or reboot
The source for this solution is this article which states that it worked on Ubuntu Cinnamon 20.04.
This is what worked on my Lenovo ThinkBook 15 G3 ACL with Ubuntu 20.04:
Edit /etc/pulse/default.pa
and remove the #
from the following line:
#set-default-source input
Then execute the following commands:
pulseaudio -k
pulseaudio --start